Five taboos in the use of turbocharger vehicles
Prevent stepping on the accelerator pedal immediately after starting, prevent long-term idling, prevent turning off the car engine immediately after high-speed operation, prevent the application of inferior engine oil, and do not clean the car when the car is hot
Because the turbine is dissipated by car oil, the oil circulation of the cold car will be poor. If the supercharger runs at a high speed, the damage will be very large. Therefore, run it at idle speed for two or three minutes, and then let the car engine run at high speed when the car oil can fully lubricate, thereby increasing the service life of the turbocharger, which seems to be very important in winter.
The turbocharger with manual transmission does not drive the vehicle in a drag gear. The drag gear means that the gear is too high and does not match the specific situation when the car is driving. If you are forced to choose a high gear when starting uphill, or when the speed is poor and high torque is required, it will cause dragging. If you drag the block, it will cause strong damage to the car engine, damage to the burner, etc.
The waiting time is too long, and many riders like not to turn off the engine while waiting for someone, but they don’t know that when the car is idling, the speed of the car is low, the speed ratio of the supercharger is also very low, and the air pressure in the turbocharger and the compressor is less than that of the rolling bearing. Due to the working pressure in the body, the leakage of automobile oil to the compressors and turbochargers on both sides will occur, and the rolling bearings cannot be relatively smooth and cooled. At the same time, the lubricating oil leaking into the compressor may enter the cylinder and endanger the automobile engine. In the regular work, so avoid running at idle speed for too long.
The speed of the turbocharger usually reaches more than 150,000 rpm, and the turbocharger of most mass-produced vehicles uses wave rolling bearings, that is, it is completely lubricated by oil. Therefore, it is very important to choose good engine oil. It is generally recommended to use the synthetic oil specified by the manufacturer or higher quality. Since the synthetic oil is three times more reliable than the general mineral oil, it can maintain the lubricating oil effect for a long time under high temperature and high-speed rotation of the automobile engine. Excellent lubrication of presses and car engines, reducing friction and damage
